New Product...


Door Lock Cover Kit




LockCap & PunchPlug

LockCap Models

Where to

Gallery of Horrors

About Us

Latest News

Contact Us


Jimmi' Jammer®



Gate Keeper®

Plate Keeper™

Light Keeper™

Top of page
Top of page
Top of page



Each LockCap™ kit contains

  • One or two LockCap™ discs, depending on the model.
  • Special RTV type, no run adhesive.
  • Complete installation instructions.

LockCap™ installation is easy! Anyone can do this...

Step 1:
Clean the lock face with rubbing alcohol. Let dry 1 minute.
Step 2:
Open the supplied adhesive.

Step 3:
Apply adhesive to LockCap™ back side.

Not too much is needed. Just enough to make good contact with the lock face.

Step 4:
Place LockCap™ onto face of lock.

Step 5:
Press lock cap into place. Hold for 10 seconds.

If any adhesive comes out around the LockCap™, use a damp cloth to wipe it off now or wait until it dries and peel it off.


Step 6:
You can drive the vehicle after about 30 minutes, but it is best to let the adhesive cure overnight for maximum strength.


Standard finish on the LockCap™ is textured black paint, closely matching the factory handle.

For colored handles, the LockCap™ can easily be painted to match the handle using factory touch-up paint.

© Redline Technical Group, Inc.1998-Current

Additional links and information...

LockCap™ Model Selection

Ready to purchase? Find out Where to Buy.

Have additional questions? Visit our LockCap™ and PunchPlug™ FAQs page.

Want to become a dealer for our products? Click here.

Warranty and product liability disclaimer.